/* * omap_udc.h -- for omap 3.2 udc, with OTG support * * 2004 (C) Texas Instruments, Inc. * 2004 (C) David Brownell */ /* * USB device/endpoint management registers */ #define UDC_REV (UDC_BASE + 0x0) /* Revision */ #define UDC_EP_NUM (UDC_BASE + 0x4) /* Which endpoint */ # define UDC_SETUP_SEL (1 << 6) # define UDC_EP_SEL (1 << 5) # define UDC_EP_DIR (1 << 4) /* low 4 bits for endpoint number */ #define UDC_DATA (UDC_BASE + 0x08) /* Endpoint FIFO */ #define UDC_CTRL (UDC_BASE + 0x0C) /* Endpoint control */ # define UDC_CLR_HALT (1 << 7) # define UDC_SET_HALT (1 << 6) # define UDC_CLRDATA_TOGGLE (1 << 3) # define UDC_SET_FIFO_EN (1 << 2) # define UDC_CLR_EP (1 << 1) # define UDC_RESET_EP (1 << 0) #define UDC_STAT_FLG (UDC_BASE + 0x10) /* Endpoint status */ # define UDC_NO_RXPACKET (1 << 15) # define UDC_MISS_IN (1 << 14) # define UDC_DATA_FLUSH (1 << 13) # define UDC_ISO_ERR (1 << 12) # define UDC_ISO_FIFO_EMPTY (1 << 9) # define UDC_ISO_FIFO_FULL (1 << 8) # define UDC_EP_HALTED (1 << 6) # define UDC_STALL (1 << 5) # define UDC_NAK (1 << 4) # define UDC_ACK (1 << 3) # define UDC_FIFO_EN (1 << 2) # define UDC_NON_ISO_FIFO_EMPTY (1 << 1) # define UDC_NON_ISO_FIFO_FULL (1 << 0) #define UDC_RXFSTAT (UDC_BASE + 0x14) /* OUT bytecount */ #define UDC_SYSCON1 (UDC_BASE + 0x18) /* System config 1 */ # define UDC_CFG_LOCK (1 << 8) # define UDC_DATA_ENDIAN (1 << 7) # define UDC_DMA_ENDIAN (1 << 6) # define UDC_NAK_EN (1 << 4) # define UDC_AUTODECODE_DIS (1 << 3) # define UDC_SELF_PWR (1 << 2) # define UDC_SOFF_DIS (1 << 1) # define UDC_PULLUP_EN (1 << 0) #define UDC_SYSCON2 (UDC_BASE + 0x1C) /* System config 2 */ # define UDC_RMT_WKP (1 << 6) # define UDC_STALL_CMD (1 << 5) # define UDC_DEV_CFG (1 << 3) # define UDC_CLR_CFG (1 << 2) #define UDC_DEVSTAT (UDC_BASE + 0x20) /* Device status */ # define UDC_B_HNP_ENABLE (1 << 9) # define UDC_A_HNP_SUPPORT (1 << 8) # define UDC_A_ALT_HNP_SUPPORT (1 << 7) # define UDC_R_WK_OK (1 << 6) # define UDC_USB_RESET (1 << 5) # define UDC_SUS (1 << 4) # define UDC_CFG (1 << 3) # define UDC_ADD (1 << 2) # define UDC_DEF (1 << 1) # define UDC_ATT (1 << 0) #define UDC_SOF (UDC_BASE + 0x24) /* Start of frame */ # define UDC_FT_LOCK (1 << 12) # define UDC_TS_OK (1 << 11) # define UDC_TS 0x03ff #define UDC_IRQ_EN (UDC_BASE + 0x28) /* Interrupt enable */ # define UDC_SOF_IE (1 << 7) # define UDC_EPN_RX_IE (1 << 5) # define UDC_EPN_TX_IE (1 << 4) # define UDC_DS_CHG_IE (1 << 3) # define UDC_EP0_IE (1 << 0) #define UDC_DMA_IRQ_EN (UDC_BASE + 0x2C) /* DMA irq enable */ /* rx/tx dma channels numbered 1-3 not 0-2 */ # define UDC_TX_DONE_IE(n) (1 << (4 * (n) - 2)) # define UDC_RX_CNT_IE(n) (1 << (4 * (n) - 3)) # define UDC_RX_EOT_IE(n) (1 << (4 * (n) - 4)) #define UDC_IRQ_SRC (UDC_BASE + 0x30) /* Interrupt source */ # define UDC_TXN_DONE (1 << 10) # define UDC_RXN_CNT (1 << 9) # define UDC_RXN_EOT (1 << 8) # define UDC_IRQ_SOF (1 << 7) # define UDC_EPN_RX (1 << 5) # define UDC_EPN_TX (1 << 4) # define UDC_DS_CHG (1 << 3) # define UDC_SETUP (1 << 2) # define UDC_EP0_RX (1 << 1) # define UDC_EP0_TX (1 << 0) # define UDC_IRQ_SRC_MASK 0x7bf #define UDC_EPN_STAT (UDC_BASE + 0x34) /* EP irq status */ #define UDC_DMAN_STAT (UDC_BASE + 0x38) /* DMA irq status */ # define UDC_DMA_RX_SB (1 << 12) # define UDC_DMA_RX_SRC(x) (((x)>>8) & 0xf) # define UDC_DMA_TX_SRC(x) (((x)>>0) & 0xf) /* DMA configuration registers: up to three channels in each direction. */ #define UDC_RXDMA_CFG (UDC_BASE + 0x40) /* 3 eps for RX DMA */ # define UDC_DMA_REQ (1 << 12) #define UDC_TXDMA_CFG (UDC_BASE + 0x44) /* 3 eps for TX DMA */ #define UDC_DATA_DMA (UDC_BASE + 0x48) /* rx/tx fifo addr */ /* rx/tx dma control, numbering channels 1-3 not 0-2 */ #define UDC_TXDMA(chan) (UDC_BASE + 0x50 - 4 + 4 * (chan)) # define UDC_TXN_EOT (1 << 15) /* bytes vs packets */ # define UDC_TXN_START (1 << 14) /* start transfer */ # define UDC_TXN_TSC 0x03ff /* units in xfer */ #define UDC_RXDMA(chan) (UDC_BASE + 0x60 - 4 + 4 * (chan)) # define UDC_RXN_STOP (1 << 15) /* enable EOT irq */ # define UDC_RXN_TC 0x00ff /* packets in xfer */ /* * Endpoint configuration registers (used before CFG_LOCK is set) * UDC_EP_TX(0) is unused */ #define UDC_EP_RX(endpoint) (UDC_BASE + 0x80 + (endpoint)*4) # define UDC_EPN_RX_VALID (1 << 15) # define UDC_EPN_RX_DB (1 << 14) /* buffer size in bits 13, 12 */ # define UDC_EPN_RX_ISO (1 << 11) /* buffer pointer in low 11 bits */ #define UDC_EP_TX(endpoint) (UDC_BASE + 0xc0 + (endpoint)*4) /* same bitfields as in RX */ /*-------------------------------------------------------------------------*/ struct omap_req { struct usb_request req; struct list_head queue; unsigned dma_bytes; unsigned mapped:1; }; struct omap_ep { struct usb_ep ep; struct list_head queue; unsigned long irqs; struct list_head iso; char name[14]; u16 maxpacket; u8 bEndpointAddress; u8 bmAttributes; unsigned double_buf:1; unsigned stopped:1; unsigned fnf:1; unsigned has_dma:1; u8 ackwait; u8 dma_channel; u16 dma_counter; int lch; struct omap_udc *udc; struct timer_list timer; }; struct omap_udc { struct usb_gadget gadget; struct usb_gadget_driver *driver; spinlock_t lock; struct omap_ep ep[32]; u16 devstat; u16 clr_halt; struct usb_phy *transceiver; struct list_head iso; unsigned softconnect:1; unsigned vbus_active:1; unsigned ep0_pending:1; unsigned ep0_in:1; unsigned ep0_set_config:1; unsigned ep0_reset_config:1; unsigned ep0_setup:1; struct completion *done; struct clk *dc_clk; struct clk *hhc_clk; unsigned clk_requested:1; }; /*-------------------------------------------------------------------------*/ #ifdef VERBOSE # define VDBG DBG #else # define VDBG(stuff...) do{}while(0) #endif #define ERR(stuff...) pr_err("udc: " stuff) #define WARNING(stuff...) pr_warn("udc: " stuff) #define INFO(stuff...) pr_info("udc: " stuff) #define DBG(stuff...) pr_debug("udc: " stuff) /*-------------------------------------------------------------------------*/ /* MOD_CONF_CTRL_0 */ #define VBUS_W2FC_1510 (1 << 17) /* 0 gpio0, 1 dvdd2 pin */ /* FUNC_MUX_CTRL_0 */ #define VBUS_CTRL_1510 (1 << 19) /* 1 connected (software) */ #define VBUS_MODE_1510 (1 << 18) /* 0 hardware, 1 software */ #define HMC_1510 ((omap_readl(MOD_CONF_CTRL_0) >> 1) & 0x3f) #define HMC_1610 (omap_readl(OTG_SYSCON_2) & 0x3f) #define HMC (cpu_is_omap15xx() ? HMC_1510 : HMC_1610) d4'>Diffstat (limited to 'include/uapi/video/sisfb.h')