/* * Header file for the Atmel DDR/SDR SDRAM Controller * * Copyright (C) 2010 Atmel Corporation * Nicolas Ferre * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; either version 2 of the License, or * (at your option) any later version. */ #ifndef AT91SAM9_DDRSDR_H #define AT91SAM9_DDRSDR_H #define AT91_DDRSDRC_MR 0x00 /* Mode Register */ #define AT91_DDRSDRC_MODE (0x7 << 0) /* Command Mode */ #define AT91_DDRSDRC_MODE_NORMAL 0 #define AT91_DDRSDRC_MODE_NOP 1 #define AT91_DDRSDRC_MODE_PRECHARGE 2 #define AT91_DDRSDRC_MODE_LMR 3 #define AT91_DDRSDRC_MODE_REFRESH 4 #define AT91_DDRSDRC_MODE_EXT_LMR 5 #define AT91_DDRSDRC_MODE_DEEP 6 #define AT91_DDRSDRC_RTR 0x04 /* Refresh Timer Register */ #define AT91_DDRSDRC_COUNT (0xfff << 0) /* Refresh Timer Counter */ #define AT91_DDRSDRC_CR 0x08 /* Configuration Register */ #define AT91_DDRSDRC_NC (3 << 0) /* Number of Column Bits */ #define AT91_DDRSDRC_NC_SDR8 (0 << 0) #define AT91_DDRSDRC_NC_SDR9 (1 << 0) #define AT91_DDRSDRC_NC_SDR10 (2 << 0) #define AT91_DDRSDRC_NC_SDR11 (3 << 0) #define AT91_DDRSDRC_NC_DDR9 (0 << 0) #define AT91_DDRSDRC_NC_DDR10 (1 << 0) #define AT91_DDRSDRC_NC_DDR11 (2 << 0) #define AT91_DDRSDRC_NC_DDR12 (3 << 0) #define AT91_DDRSDRC_NR (3 << 2) /* Number of Row Bits */ #define AT91_DDRSDRC_NR_11 (0 << 2) #define AT91_DDRSDRC_NR_12 (1 << 2) #define AT91_DDRSDRC_NR_13 (2 << 2) #define AT91_DDRSDRC_NR_14 (3 << 2) #define AT91_DDRSDRC_CAS (7 << 4) /* CAS Latency */ #define AT91_DDRSDRC_CAS_2 (2 << 4) #define AT91_DDRSDRC_CAS_3 (3 << 4) #define AT91_DDRSDRC_CAS_25 (6 << 4) #define AT91_DDRSDRC_RST_DLL (1 << 7) /* Reset DLL */ #define AT91_DDRSDRC_DICDS (1 << 8) /* Output impedance control */ #define AT91_DDRSDRC_DIS_DLL (1 << 9) /* Disable DLL [SAM9 Only] */ #define AT91_DDRSDRC_OCD (1 << 12) /* Off-Chip Driver [SAM9 Only] */ #define AT91_DDRSDRC_DQMS (1 << 16) /* Mask Data is Shared [SAM9 Only] */ #define AT91_DDRSDRC_ACTBST (1 << 18) /* Active Bank X to Burst Stop Read Access Bank Y [SAM9 Only] */ #define AT91_DDRSDRC_T0PR 0x0C /* Timing 0 Register */ #define AT91_DDRSDRC_TRAS (0xf << 0) /* Active to Precharge delay */ #define AT91_DDRSDRC_TRCD (0xf << 4) /* Row to Column delay */ #define AT91_DDRSDRC_TWR (0xf << 8) /* Write recovery delay */ #define AT91_DDRSDRC_TRC (0xf << 12) /* Row cycle delay */ #define AT91_DDRSDRC_TRP (0xf << 16) /* Row precharge delay */ #define AT91_DDRSDRC_TRRD (0xf << 20) /* Active BankA to BankB */ #define AT91_DDRSDRC_TWTR (0x7 << 24) /* Internal Write to Read delay */ #define AT91_DDRSDRC_RED_WRRD (0x1 << 27) /* Reduce Write to Read Delay [SAM9 Only] */ #define AT91_DDRSDRC_TMRD (0xf << 28) /* Load mode to active/refresh delay */ #define AT91_DDRSDRC_T1PR 0x10 /* Timing 1 Register */ #define AT91_DDRSDRC_TRFC (0x1f << 0) /* Row Cycle Delay */ #define AT91_DDRSDRC_TXSNR (0xff << 8) /* Exit self-refresh to non-read */ #define AT91_DDRSDRC_TXSRD (0xff << 16) /* Exit self-refresh to read */ #define AT91_DDRSDRC_TXP (0xf << 24) /* Exit power-down delay */ #define AT91_DDRSDRC_T2PR 0x14 /* Timing 2 Register [SAM9 Only] */ #define AT91_DDRSDRC_TXARD (0xf << 0) /* Exit active power down delay to read command in mode "Fast Exit" */ #define AT91_DDRSDRC_TXARDS (0xf << 4) /* Exit active power down delay to read command in mode "Slow Exit" */ #define AT91_DDRSDRC_TRPA (0xf << 8) /* Row Precharge All delay */ #define AT91_DDRSDRC_TRTP (0x7 << 12) /* Read to Precharge delay */ #define AT91_DDRSDRC_LPR 0x1C /* Low Power Register */ #define AT91_DDRSDRC_LPCB (3 << 0) /* Low-power Configurations */ #define AT91_DDRSDRC_LPCB_DISABLE 0 #define AT91_DDRSDRC_LPCB_SELF_REFRESH 1 #define AT91_DDRSDRC_LPCB_POWER_DOWN 2 #define AT91_DDRSDRC_LPCB_DEEP_POWER_DOWN 3 #define AT91_DDRSDRC_CLKFR (1 << 2) /* Clock Frozen */ #define AT91_DDRSDRC_PASR (7 << 4) /* Partial Array Self Refresh */ #define AT91_DDRSDRC_TCSR (3 << 8) /* Temperature Compensated Self Refresh */ #define AT91_DDRSDRC_DS (3 << 10) /* Drive Strength */ #define AT91_DDRSDRC_TIMEOUT (3 << 12) /* Time to define when Low Power Mode is enabled */ #define AT91_DDRSDRC_TIMEOUT_0_CLK_CYCLES (0 << 12) #define AT91_DDRSDRC_TIMEOUT_64_CLK_CYCLES (1 << 12) #define AT91_DDRSDRC_TIMEOUT_128_CLK_CYCLES (2 << 12) #define AT91_DDRSDRC_APDE (1 << 16) /* Active power down exit time */ #define AT91_DDRSDRC_UPD_MR (3 << 20) /* Update load mode register and extended mode register */ #define AT91_DDRSDRC_MDR 0x20 /* Memory Device Register */ #define AT91_DDRSDRC_MD (7 << 0) /* Memory Device Type */ #define AT91_DDRSDRC_MD_SDR 0 #define AT91_DDRSDRC_MD_LOW_POWER_SDR 1 #define AT91_DDRSDRC_MD_LOW_POWER_DDR 3 #define AT91_DDRSDRC_MD_DDR2 6 /* [SAM9 Only] */ #define AT91_DDRSDRC_DBW (1 << 4) /* Data Bus Width */ #define AT91_DDRSDRC_DBW_32BITS (0 << 4) #define AT91_DDRSDRC_DBW_16BITS (1 << 4) #define AT91_DDRSDRC_DLL 0x24 /* DLL Information Register */ #define AT91_DDRSDRC_MDINC (1 << 0) /* Master Delay increment */ #define AT91_DDRSDRC_MDDEC (1 << 1) /* Master Delay decrement */ #define AT91_DDRSDRC_MDOVF (1 << 2) /* Master Delay Overflow */ #define AT91_DDRSDRC_MDVAL (0xff << 8) /* Master Delay value */ #define AT91_DDRSDRC_HS 0x2C /* High Speed Register [SAM9 Only] */ #define AT91_DDRSDRC_DIS_ATCP_RD (1 << 2) /* Anticip read access is disabled */ #define AT91_DDRSDRC_DELAY(n) (0x30 + (0x4 * (n))) /* Delay I/O Register n */ #define AT91_DDRSDRC_WPMR 0xE4 /* Write Protect Mode Register [SAM9 Only] */ #define AT91_DDRSDRC_WP (1 << 0) /* Write protect enable */ #define AT91_DDRSDRC_WPKEY (0xffffff << 8) /* Write protect key */ #define AT91_DDRSDRC_KEY (0x444452 << 8) /* Write protect key = "DDR" */ #define AT91_DDRSDRC_WPSR 0xE8 /* Write Protect Status Register [SAM9 Only] */ #define AT91_DDRSDRC_WPVS (1 << 0) /* Write protect violation status */ #define AT91_DDRSDRC_WPVSRC (0xffff << 8) /* Write protect violation source */ #endif an oops immediately afterwards as the (inlined) call to i915_vma_unpin_fence() tries to dereference it. It seems to be some race condition where the object is going away at shutdown time, since both times happened when shutting down the X server. The call chains were different: - VT ioctl(KDSETMODE, KD_TEXT): intel_cleanup_plane_fb+0x5b/0xa0 [i915] drm_atomic_helper_cleanup_planes+0x6f/0x90 [drm_kms_helper] intel_atomic_commit_tail+0x749/0xfe0 [i915] intel_atomic_commit+0x3cb/0x4f0 [i915] drm_atomic_commit+0x4b/0x50 [drm] restore_fbdev_mode+0x14c/0x2a0 [drm_kms_helper] drm_fb_helper_restore_fbdev_mode_unlocked+0x34/0x80 [drm_kms_helper] drm_fb_helper_set_par+0x2d/0x60 [drm_kms_helper] intel_fbdev_set_par+0x18/0x70 [i915] fb_set_var+0x236/0x460 fbcon_blank+0x30f/0x350 do_unblank_screen+0xd2/0x1a0 vt_ioctl+0x507/0x12a0 tty_ioctl+0x355/0xc30 do_vfs_ioctl+0xa3/0x5e0 SyS_ioctl+0x79/0x90 entry_SYSCALL_64_fastpath+0x13/0x94 - i915 unpin_work workqueue: intel_unpin_work_fn+0x58/0x140 [i915] process_one_work+0x1f1/0x480 worker_thread+0x48/0x4d0 kthread+0x101/0x140 and this patch purely papers over the issue by adding a NULL pointer check and a WARN_ON_ONCE() to avoid the oops that would then generally make the machine unresponsive. Other callers of i915_gem_object_to_ggtt() seem to also check for the returned pointer being NULL and warn about it, so this clearly has happened before in other places. [ Reported it originally to the i915 developers on Jan 8, applying the ugly workaround on my own now after triggering the problem for the second time with no feedback. This is likely to be the same bug reported as https://bugs.freedesktop.org/show_bug.cgi?id=98829 https://bugs.freedesktop.org/show_bug.cgi?id=99134 which has a patch for the underlying problem, but it hasn't gotten to me, so I'm applying the workaround. ] Cc: Daniel Vetter <daniel.vetter@intel.com> Cc: Jani Nikula <jani.nikula@linux.intel.com> Cc: Ville Syrjälä <ville.syrjala@linux.intel.com> Cc: Chris Wilson <chris@chris-wilson.co.uk> Cc: Maarten Lankhorst <maarten.lankhorst@linux.intel.com> Cc: Tvrtko Ursulin <tvrtko.ursulin@intel.com> Cc: Imre Deak <imre.deak@intel.com> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Diffstat (limited to 'tools/perf/builtin-version.c')