/*
* wm8962.h -- WM8962 Soc Audio driver platform data
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef _WM8962_PDATA_H
#define _WM8962_PDATA_H
#define WM8962_MAX_GPIO 6
/* Use to set GPIO default values to zero */
#define WM8962_GPIO_SET 0x10000
#define WM8962_GPIO_FN_CLKOUT 0
#define WM8962_GPIO_FN_LOGIC 1
#define WM8962_GPIO_FN_SDOUT 2
#define WM8962_GPIO_FN_IRQ 3
#define WM8962_GPIO_FN_THERMAL 4
#define WM8962_GPIO_FN_PLL2_LOCK 6
#define WM8962_GPIO_FN_PLL3_LOCK 7
#define WM8962_GPIO_FN_FLL_LOCK 9
#define WM8962_GPIO_FN_DRC_ACT 10
#define WM8962_GPIO_FN_WSEQ_DONE 11
#define WM8962_GPIO_FN_ALC_NG_ACT 12
#define WM8962_GPIO_FN_ALC_PEAK_LIMIT 13
#define WM8962_GPIO_FN_ALC_SATURATION 14
#define WM8962_GPIO_FN_ALC_LEVEL_THR 15
#define WM8962_GPIO_FN_ALC_LEVEL_LOCK 16
#define WM8962_GPIO_FN_FIFO_ERR 17
#define WM8962_GPIO_FN_OPCLK 18
#define WM8962_GPIO_FN_DMICCLK 19
#define WM8962_GPIO_FN_DMICDAT 20
#define WM8962_GPIO_FN_MICD 21
#define WM8962_GPIO_FN_MICSCD 22
struct wm8962_pdata {
struct clk *mclk;
int gpio_base;
u32 gpio_init[WM8962_MAX_GPIO];
/* Setup for microphone detection, raw value to be written to
* R48(0x30) - only microphone related bits will be updated.
* Detection may be enabled here for use with signals brought
* out on the GPIOs. */
u32 mic_cfg;
bool irq_active_low;
bool spk_mono; /* Speaker outputs tied together as mono */
/**
* This flag should be set if one or both IN4 inputs is wired
* in a DC measurement configuration.
*/
bool in4_dc_measure;
};
#endif
t.git/log/sound/usb/6fire/pcm.h?h=nds-private-remove'>logtreecommitdiff
Merge tag 'rtc-4.10-2' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux
Pull RTC fix from Alexandre Belloni:
"A single fix for this cycle. It is worth taking it for 4.10 so that
distributions will not have CONFIG_RTC_DRV_JZ4740 switching from m to
y in their config.
Summary:
- Allow jz4740 to build as a module again by using kernel_halt()"
* tag 'rtc-4.10-2' of git://git.kernel.org/pub/scm/linux/kernel/git/abelloni/linux:
rtc: jz4740: make the driver buildable as a module again