#
# MPLS configuration
#
menuconfig MPLS
bool "MultiProtocol Label Switching"
default n
---help---
MultiProtocol Label Switching routes packets through logical
circuits. Originally conceived as a way of routing packets at
hardware speeds (before hardware was capable of routing ipv4 packets),
MPLS remains a simple way of making tunnels.
If you have not heard of MPLS you probably want to say N here.
if MPLS
config NET_MPLS_GSO
tristate "MPLS: GSO support"
help
This is helper module to allow segmentation of non-MPLS GSO packets
that have had MPLS stack entries pushed onto them and thus
become MPLS GSO packets.
config MPLS_ROUTING
tristate "MPLS: routing support"
---help---
Add support for forwarding of mpls packets.
config MPLS_IPTUNNEL
tristate "MPLS: IP over MPLS tunnel support"
depends on LWTUNNEL && MPLS_ROUTING
---help---
mpls ip tunnel support.
endif # MPLS
ame='id' value='28ac7dcd5b1354e46f5f28a53b5a6b443fcc88ed'/>
Since the commit b0ca2a21f769 ("sh_eth: Add support of SH7763 to sh_eth")
the *enum* declaring the EESIPR bits (interrupt mask) went out of sync with
the *enum* declaring the EESR bits (interrupt status) WRT bit naming and
formatting. I'd like to restore the consistency by using EESIPR as the bit
name prefix, renaming the *enum* to EESIPR_BIT, and (finally) renaming the
bits according to the available Renesas SH77{34|63} manuals; additionally,
reconstruct couple names using the EESR bit declaration above...
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>