# kbuild trick to avoid linker error. Can be omitted if a module is built.
obj- := dummy.o
hostprogs-$(CONFIG_SAMPLE_SECCOMP) := bpf-fancy dropper bpf-direct
HOSTCFLAGS_bpf-fancy.o += -I$(objtree)/usr/include
HOSTCFLAGS_bpf-fancy.o += -idirafter $(objtree)/include
HOSTCFLAGS_bpf-helper.o += -I$(objtree)/usr/include
HOSTCFLAGS_bpf-helper.o += -idirafter $(objtree)/include
bpf-fancy-objs := bpf-fancy.o bpf-helper.o
HOSTCFLAGS_dropper.o += -I$(objtree)/usr/include
HOSTCFLAGS_dropper.o += -idirafter $(objtree)/include
dropper-objs := dropper.o
HOSTCFLAGS_bpf-direct.o += -I$(objtree)/usr/include
HOSTCFLAGS_bpf-direct.o += -idirafter $(objtree)/include
bpf-direct-objs := bpf-direct.o
# Try to match the kernel target.
ifndef CROSS_COMPILE
ifndef CONFIG_64BIT
# s390 has -m31 flag to build 31 bit binaries
ifndef CONFIG_S390
MFLAG = -m32
else
MFLAG = -m31
endif
HOSTCFLAGS_bpf-direct.o += $(MFLAG)
HOSTCFLAGS_dropper.o += $(MFLAG)
HOSTCFLAGS_bpf-helper.o += $(MFLAG)
HOSTCFLAGS_bpf-fancy.o += $(MFLAG)
HOSTLOADLIBES_bpf-direct += $(MFLAG)
HOSTLOADLIBES_bpf-fancy += $(MFLAG)
HOSTLOADLIBES_dropper += $(MFLAG)
endif
always := $(hostprogs-m)
else
# MIPS system calls are defined based on the -mabi that is passed
# to the toolchain which may or may not be a valid option
# for the host toolchain. So disable tests if target architecture
# is MIPS but the host isn't.
ifndef CONFIG_MIPS
always := $(hostprogs-m)
endif
endif
type='submit' value='switch'/>
Merge tag 'regulator-fix-v4.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator
Pull regulator fixes from Mark Brown:
"Three changes here: two run of the mill driver specific fixes and a
change from Mark Rutland which reverts some new device specific ACPI
binding code which was added during the merge window as there are
concerns about this sending the wrong signal about usage of regulators
in ACPI systems"
* tag 'regulator-fix-v4.10-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator:
regulator: fixed: Revert support for ACPI interface
regulator: axp20x: AXP806: Fix dcdcb being set instead of dcdce
regulator: twl6030: fix range comparison, allowing vsel = 59