# # This config is an example usage of ktest.pl with a kvm guest # # The guest is called 'Guest' and this would be something that # could be run on the host to test a virtual machine target. MACHINE = Guest # Use virsh to read the serial console of the guest CONSOLE = virsh console ${MACHINE} # Use SIGKILL to terminate virsh console. We can't kill virsh console # by the default signal, SIGINT. CLOSE_CONSOLE_SIGNAL = KILL #*************************************# # This part is the same as test.conf # #*************************************# # The include files will set up the type of test to run. Just set TEST to # which test you want to run. # # TESTS = patchcheck, randconfig, boot, test, config-bisect, bisect, min-config # # See the include/*.conf files that define these tests # TEST := patchcheck # Some tests may have more than one test to run. Define MULTI := 1 to run # the extra tests. MULTI := 0 # In case you want to differentiate which type of system you are testing BITS := 64 # REBOOT = none, error, fail, empty # See include/defaults.conf REBOOT := empty # The defaults file will set up various settings that can be used by all # machine configs. INCLUDE include/defaults.conf #*************************************# # Now we are different from test.conf # #*************************************# # The example here assumes that Guest is running a Fedora release # that uses dracut for its initfs. The POST_INSTALL will be executed # after the install of the kernel and modules are complete. # POST_INSTALL = ${SSH} /sbin/dracut -f /boot/initramfs-test.img $KERNEL_VERSION # Guests sometimes get stuck on reboot. We wait 3 seconds after running # the reboot command and then do a full power-cycle of the guest. # This forces the guest to restart. # POWERCYCLE_AFTER_REBOOT = 3 # We do the same after the halt command, but this time we wait 20 seconds. POWEROFF_AFTER_HALT = 20 # As the defaults.conf file has a POWER_CYCLE option already defined, # and options can not be defined in the same section more than once # (all DEFAULTS sections are considered the same). We use the # DEFAULTS OVERRIDE to tell ktest.pl to ignore the previous defined # options, for the options set in the OVERRIDE section. # DEFAULTS OVERRIDE # Instead of using the default POWER_CYCLE option defined in # defaults.conf, we use virsh to cycle it. To do so, we destroy # the guest, wait 5 seconds, and then start it up again. # Crude, but effective. # POWER_CYCLE = virsh destroy ${MACHINE}; sleep 5; virsh start ${MACHINE} DEFAULTS # The following files each handle a different test case. # Having them included allows you to set up more than one machine and share # the same tests. INCLUDE include/patchcheck.conf INCLUDE include/tests.conf INCLUDE include/bisect.conf INCLUDE include/min-config.conf t/log/?id=9588397d24eecb7298bce9307b589a5bc0ccafdd&showmsg=1'>root/include/dt-bindings/gpio/gpio.h
AgeCommit message (Collapse)AuthorFilesLines