| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
Add EEE802.3X Ethernet MAC Control PAUSE frame proto header with two
fields - opcode & time.
By default Ethernet header is pushed on header init.
Signed-off-by: Vadim Kochan <vadim4j@gmail.com>
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
|
Add support for MPLS header creating with fields:
Label, TClass, Bottom-Stack, TTL
By default S-field is set to 1 (last label), but resets to 0
if lower MPLS header is added.
Signed-off-by: Vadim Kochan <vadim4j@gmail.com>
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
|
Add generation of VLAN header with supported fields:
TPID, DEI/CFI, PCP, VID
Changed struct proto_field.offset uint16_t -> int16_t to make
TPID offset -2 to point to ether type.
Signed-off-by: Vadim Kochan <vadim4j@gmail.com>
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
|
The IEEE 802.3 standard commonly refers to the field specifying the
upper layer protocol as Ethertype, not protocol. Thus, also support the
keywords "etype" and "type" for this field.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
|
Add ARP protocol header fields generation. By default htype ethernet (1)
and ptype IPv4 (0x0800) and the corresponding hlen/plen values will be
initialized and the opcode is set to ARP Request (1).
Source MAC and IP address are set to the device's addresses if not
specified.
Signed-off-by: Vadim Kochan <vadim4j@gmail.com>
[tk: rephrase and extend commit message]
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
|
Add trafgen_l2.c module for generating L2 related headers.
Add Ethernet header generating. By default source MAC address
is used from the specified output device.
Signed-off-by: Vadim Kochan <vadim4j@gmail.com>
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
|
