From 815dcd255ea9da8b23e8e7c839545d5d41eee336 Mon Sep 17 00:00:00 2001 From: Jon Schipp Date: Mon, 4 Aug 2014 20:39:13 +0000 Subject: mausezahn: provide listen-addr option to configuration file Specify the listen-addr for the CLI in /etc/netsniff-ng/mausezahn.conf and remove the message, "mz: device not given, will use eth0" since we're listening by IP, rather than interface now, and this shows continues to show. $ grep listen-addr /etc/netsniff-ng/mausezahn.conf listen-addr = 127.0.0.1 $ mausezahn -V -x mz: device eth0 got assigned 10.0.2.15 and is a possible candidate. mz: device lo got assigned 127.0.0.1 (loopback) Opening config file /etc/netsniff-ng/mausezahn.conf... ... Mausezahn accepts incoming Telnet connections on 127.0.0.1:25542. Signed-off-by: Jon Schipp Signed-off-by: Tobias Klauser --- mausezahn.8 | 2 ++ 1 file changed, 2 insertions(+) (limited to 'mausezahn.8') diff --git a/mausezahn.8 b/mausezahn.8 index e094e9b..24e829e 100644 --- a/mausezahn.8 +++ b/mausezahn.8 @@ -231,6 +231,7 @@ Options supported in the configuration file are: password Password for authentication (default: mz) enable Password to enter privilege mode (default: mops) port The listening port for the CLI (default: 25542) + listen-addr IP address to bind CLI to (default: 0.0.0.0) management-only Set management interface (no data traffic is allowed to pass through) cli-device Interface to bind CLI to (default: all) *not fully implemented* automops Path to automops file (contains XML data describing protocols) *in development* @@ -242,6 +243,7 @@ Options supported in the configuration file are: password = mzpasswd enable = privilege-mode-passwd port = 65000 + listen-addr = 127.0.0.1 .PP .SH INTERACTIVE MODE HOWTO .PP -- cgit v1.2.3-54-g00ecf